All Categories
News

Home /  News

NEWS

Warehouse High Bay Motion Sensors: Planning Coverage by Zone

Nov 12, 2026

Motion sensors for warehouse high bays should be selected around how people and vehicles move through the building. A narrow rack aisle, a loading area and an open staging zone can have similar ceiling heights and very different detection needs. Define those zones before selecting sensors or assigning fixtures to control groups.

Rack aisle high bay lighting application concept
Linear high bay with a sensor at the center of the fixture

Map the paths that should trigger each zone

Mark aisle entrances, cross-aisles, picking positions and forklift approaches on a plan. In a rack aisle, decide where lighting should respond as a person or vehicle enters and whether motion in the next aisle should affect it. In staging areas, include routes around temporary pallets and positions where people may work with little movement. Confirm whether each sensor controls one fixture or a defined group, and identify the adjacent areas where you want independent response.

Read the coverage diagram at the proposed mounting height

Request the detection pattern for the proposed sensor, lens and actual sensor mounting height. Fixture light distribution and sensor detection coverage are separate drawings. Look at both the cross-aisle and along-aisle directions and check any stated differences in response to movement toward or across the sensor. Account for rack height, stored goods and obstructions. If the available diagram shows only an open floor, ask how the supplier would lay out the sensors for your rack arrangement and confirm the proposal on site.

Motion sensor fixture and an illustrative forklift detection example
Open workshop high bay lighting application concept

Test with normal traffic and work patterns

During a pilot, walk and drive representative routes under normal operating conditions. Check aisle entry, far ends and adjacent zones for delayed or unwanted triggers. Observe people working at picking stations where motion may be intermittent. Confirm the supported hold time and standby behavior, then adjust the settings with the site team around actual operations. Record the approved sensor, mounting height, control groups and settings before repeating the layout.

Explore Noon Lighting’s LED linear high bays. When you ask about sensor options, share your rack layout, sensor mounting height and the behavior you want in each zone.

News